Belkin OmniView PRO Guide De L'utilisateur page 14

P73055/F1D108-OSD/EU/man.qxd
• Upon connecting the daisy-chain cable to the previous unit, it should automatically
power up if the previous unit is powered up. However, it is still recommended that the
power supply be used with the slave unit. You will see the LED display on the front
panel show the units bank address setting.
• RESET the MASTER unit by pressing the BANK/SCAN and CHANNEL buttons
simultaneously. This is necessary for the MASTER unit to detect the newly added slave unit.
• Verify that the MASTER unit has detected the new slave by pressing the BANK/SCAN
button. If it detected the new slave properly, the LED display on the MASTER will
register the slave units bank address. If you have many slave units, you may have to
press the BANK/SCAN button many times to cycle through all of the preexisting slave
units before reaching the newly added unit.
• Now you can power up the computers connected to the newly added slave unit. After
all the computers have booted up, you may need to RESET the MASTER unit again to
detect the presence of powered computers on the new slave unit.
NOTE: The OmniView
F1D104 only). This gives the user more selection and flexibility. When doing this, it is
desirable to have the OmniView
Display (OSD) menu feature. Thus, all the units will benefit from the OSD control, even
if the OmniView
4/21/00 2:25 PM
Hardware Installation
™ PRO can also be daisy-chained to OmniView
™
SE does not have the OSD feature.
™
Page 10
(continued)
PRO as the MASTER unit because of the On-Screen
10
™ SE units (F1D102 and