Makita DHR280 Manuel D'instruction page 13

Dust cup
Optional accessory
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the figure. The size of bits which the dust cup can be
attached to is as follows.
Model
Dust cup 5
Dust cup 9
► 1 . Dust cup
Dust cup set
Optional accessory
Before installing the dust cup set, remove the bit from
the tool if installed.
Install the dust cup set on the tool so that the
bol on the dust cup is aligned with the groove in the tool.
► 1 . symbol 2. Groove
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
1
sym-
1
2
NOTE: If you connect a vacuum cleaner to the dust
cup set, remove the dust cap before connecting it.
1
► 1 . Dust cap
To remove the dust cup set, remove the bit while pulling
the chuck cover in the direction of the arrow.
► 1 . Bit 2. Chuck cover
Hold the root of dust cup and pull it out.
13 ENGLISH
1
2