Handling Batteries; Material Damage; Unpacking, Setting Up And Inserting The Batteries; Mounting The Appliance - SilverCrest SKD 2300 A1 Mode D'emploi

RP90866 Konvektor LB1 Seite 53 Dienstag, 2. Juli 2013 3:36 15
• The remote control contains batteries.
Ensure that they are kept out of the reach
of children and are not swallowed.
Ingested batteries
dangerous. Obtain medical assistance
immediately if batteries are swallowed.

4.7 Handling batteries

Warning!
To prevent a risk of explosion,
normal batteries must not be
charged, heated or disposed of by
burning.
If battery acid has leaked, avoid
contact with skin, eyes and mucous
membranes to prevent injury. In the
event of contact with the acid, rinse
the affected areas immediately
with plenty of clean water and
contact a doctor at once.
Caution! To avoid damaging the product
and ensure it functions correctly, please
note:

5. Unpacking, setting up and inserting the batteries

5.1 Mounting the appliance

Before the appliance can be used, the feet 7
must be screwed on as follows:
1. Unpack the
packaging.
2. Remove the transport packaging.
3. Check that the appliance shows no signs
of damage.
4. Slide the feet 7 from the outside into the
corresponding
underside of the convector.
5. Secure the feet 7 firmly using the screws
supplied.
SKD 2300 A1
can be highly
appliance from the
supports on the
• Always replace all batteries at the same
time.
• Do not use different battery types or a
mixture of new and old batteries at the
same time.
• Do not short circuit the batteries.
• Remove the batteries if the device is not
used for a long time. Leaking batteries
could damage the device.

4.8 Material damage

Caution! To avoid material damage,
please observe the following conditions.
• Remove the batteries from the remote
control if you are not using it for a
prolonged period of time. Leaking
batteries could damage the remote
control.
• Ensure that the feet are fitted correctly
(see "5.2 Setting up the appliance" on
page 53), otherwise the floor might be
scratched or scorched.

5.2 Setting up the appliance

Note: As the appliance and heating
elements are supplied with a thin film of
grease, there might be a small amount of
smoke and odour the first time the appliance
is used. This is not harmful and will stop after
a short while. Please ensure meanwhile that
there is sufficient ventilation.
Warning! Ensure that there is
sufficient distance from the wall,
fixtures and other appliances. The
distance must be at least 1 m to
exclude the risk of fire.
53