Installation Of Safety Support; Electrical Connections - Kichler Jade Manuel D'instruction

6. INSTALLATION OF SAFETY SUPPORT

(Required for Canadian installation ONLY)
A safety support cable is provided to help prevent the
ceiling fan from falling, please install it as follows.
Step 1. Attach the provided wood screw and washers
to the ceiling joist next to the mounting bracket but do
not tighten. (Fig. 11)
Step 2. Adjust the length of the safety cable to reach
the screw and washers by pulling the extra cable
through the cable clamp until the overall length is
correct, put the end of the cable back through the cable
clamp, forming a loop at the end of the cable. Tighten
the cable clamp securely. Now, put the loop in the end
of the safety cable over the wood screw securely.
NOTE
: Although the safety support cable is required
for Canadian installations only. It's a good idea to make
the attachment with any installation.

7. ELECTRICAL CONNECTIONS

WARNING:
To avoid possible electrical shock, be sure
you have turned off the power at the main circuit panel.
NOTE
: The frequencies on your receiver and wall
transmitter have been preset at the factory. Before
installing the receiver, make sure the dip switches on
the receiver and wall transmitter are set to the same
frequency. (Fig. 12)
Step 1. Insert the receiver into the ceiling mounting
bracket with the flat side of the receiver facing the
ceiling. (Fig. 13)
For best performance, make sure the Black antenna,
on the end of the receiver, remains extended and not
tangled with any of the electrical wires.
60" Jade
Hanger bracket
Safety cable
Fig. 11
Code switch
ON
HI
ON ECE
MED
1 2 3 4
LOW
FAN OFF
ON ECE
1 2 3 4
Fig. 12
Receiver
Fig. 13
6
Attach safety cable
to ceiling joist with
screw and washer
Hanger
bracket