Description Of Symbols - Silverline 982593 Mode D'emploi

GB
Introduction
Thank you for purchasing this Silverline tool. This manual contains information
necessary for safe and effective operation of this product. This product has
unique features and, even if you are familiar with similar products, it is necessary
to read this manual carefully to ensure you fully understand the instructions.
Ensure all users of the tool read and fully understand this manual.

Description of Symbols

The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use.
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Caution!
Class II construction (double insulated for additional protection
Conforms to relevant legislation and safety standards
Environmental Protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice
Technical Abbreviations Key
V Volts
~
Alternating current
A
Ampere
n No load speed
o
Hz Hertz
W, kW
Watt, kilowatt
/min or min (revolutions or reciprocation) per minute
-1
4
Original Instructions
Specification
Voltage: .......................................................... 230-240V~, 50Hz
Power: ........................................................................... 1500W
No load speed: .........................................................0-800min
Chuck: ......................................................................... SDS Plus
Impact rate: ............................................................ 0-4200bpm
Impact energy: .................................................................... 5.5J
Safety clutch (operates at or below): .................................54Nm
Keyed chuck (accessory): ........................................ 13mm (
Max drilling capacities:
- Concrete ................................................................... Ø 32mm
- Wood ..........................................................................Ø 40mm
- Steel .......................................................................... Ø 13mm
Power cord length: ............................................................ 2.0 m
Ingress protection: .............................................................. IP20
Protection class: ..................................................................
Dimensions (L x W x H): ............................... 390 x 95 x 280mm
Weight: ............................................................................. 5.5kg
Sound and vibration information:
Sound Pressure L : ...................................................96.4dB(A)
PA
Sound Power L : ....................................................107.4dB(A)
WA
Uncertainty K: ..................................................................... 3dB
Weighted vibration a (main handle): ........................ 19.327m/s
h
a (auxiliary handle): .................. 17.879m/s
h
Uncertainty K: ............................................................... 1.5m/s
The sound intensity level for the operator may exceed 85dB(A) and
sound protection measures are necessary.
As part of our ongoing product development, specifications of Silverline
products may alter without notice.
WARNING: Always wear ear protection where the sound level exceeds
85dB(A) and limit the time of exposure if necessary. If sound levels are
uncomfortable, even with ear protection, stop using the tool immediately
and check the ear protection is correctly fitted and provides the correct level
of sound attenuation for the level of sound produced by your tool.
WARNING: User exposure to tool vibration can result in loss of sense of
touch, numbness, tingling and reduced ability to grip. Long term exposure
can lead to a chronic condition. If necessary, limit the length of time
exposed to vibration and use anti-vibration gloves. Do not operate the tool
with hands below a normal comfortable temperature, as vibration will have
a greater effect. Use the figures provided in the specification relating to
vibration to calculate the duration and frequency of operating the tool.
Sound and vibration levels in the specification are determined according
to EN60745 or similar international standards. The figures represent
normal use for the tool in normal working conditions. A poorly maintained,
incorrectly assembled, or misused tool, may produce increased levels of
noise and vibration. www.osha.europa.eu provides information on sound
and vibration levels in the workplace that may be useful to domestic users
who use tools for long periods of time.
-1
⁄ ")
1
2
2
2
2