Connecting The Tv Signal Sources - HP Pavilion Serie Mode D'emploi

mb5ltvsh.book Page 11 Monday, June 27, 2005 1:58 PM
To use a separate external amplifier or a stereo system,
refer to "Connecting an external sound system" on
page 24.
CAUTION: Unplug power for the TV and all
connected components before attaching or
connecting speakers.
1
Position the TV display upright on its stand.
2
Place a speaker onto the TV display and insert the
screws to secure it. Use the long screws for the top
and bottom, and the short screw in the middle.
Select models use only two screws.

Connecting the TV signal sources

The following is an explanation of the types of
connections that are used for a coaxial cable. If your
outdoor antenna uses a 75-ohm coaxial cable with an
F-type connector, plug it into the antenna terminal at
the rear of the TV set.
c
3
Plug the speaker into the TV.
4
Repeat these steps for the other speaker.
A 75-ohm system is generally a round cable with
■
an F-type connector that can easily be attached to
a terminal without tools (sold separately).
A 300-ohm system is a flat, twin-lead cable that
■
can be attached to a 75-ohm terminal through a
300/75-ohm adapter (sold separately).
11
Setting Up