Installation Instruction - Faber NIVA Mode D'emploi

voltage.Before switching on, please read the safety warnings and operating instructions.
PLEASE RETAIN THIS USER'S GUIDE FOR FUTURE REFERENCE
Only use fi ltered tap water in this appliance.
Always ensure that the appliance is sitting on a level surface.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and
dry the sump.
Once installed, never move this appliance or lay on its back, without draining the water from sump and water
tank.
The water tank, sump, sump lid, tank cap and air fi lters must be cleaned once every two weeks, particularly in
hard water areas.
The appliance should never be operated if the lamps are not working.
The lamps should be regularly inspected as described under 'Maintenance' and 'Changing lamps'.

Installation Instruction

Before installing this appliance in an existing chimnney, we recommend that;
1. You have your chimney cleaned by a competent chimney sweep.
2. You block off the chimney fl ue.
This procedure is important for the effi cient operation of the heating unit and will also reduce heat loss up the chimney.
Installation.
Ensure that all packing items are removed (read any warning labels carefully).
Retain all packing for possible future use e.g. in the event of moving or returning the appliance to your
supplier.
To install the appliance;
1. Clean the area where the fi re will be installed e.g remove ash residue from an existing fi replace.
2. Use the two adjustable supports at the rear of the appliance to ensure that the fi re is level.
3. Make sure the unit is switched OFF.
4. Hold the fi re by the sides of surround and gently manoeuvre into position. Plug the fi re into a 13amp/240 volt outlet.
Ensure that the supply cable is not trapped under the fi re such that it might cause it to be damaged.
Before using the manual controls fi rstly fi ll the water tank (See 'Maintenance', 'Filling the water tank').
Operating the Fire
Manual Controls.
The OPTIMYST manual controls are located beneath the hinged canopy. Raise the canopy to access the controls.
(See Fig.2 for Manual Control lay out)
Switch 'A':- Controls the electricity supply to the Fire.
Note: This switch must be in the 'ON' ( I ) position for the Fire to operate either with or without heat.
Switch 'B':- Press once to turn on the fl ame effect. This will be indicated by an audible beep. Although the main
lights operate immediately it will take a further 30 seconds before the fl ame effect starts.
Press again to give fl ame effect and half heat. This will be indicated by two beeps.
Press again to give fl ame effect and full heat. This will be indicated by three beeps.
Press again to return to fl ame effect only. This will be indicated by one beep.
Press to put fi re in to standby mode. This will be indicated by one beep.
Control Knob 'C':- Controls the Thermostat setting.
Turning the control knob Anti Clockwise will decrease the temperature setting, turning the control knob
Clockwise will increase the temperature setting.
Control Knob 'D':- Controls the intensity of the fl ame effect.
Turning the control knob Anti Clockwise increases the fl ame effect, turning the control knob Clockwise will
decrease the fl ame effect.
When the water in the tank and in the sump runs out the main lamps will go out. See instructions under 'Maintenance',
'Filling the water tank'. When this procedure is complete, the main lamps will illuminate but it will take 30 seconds
before the fl ames return.
Setting the Thermostat
Plug in and switch on the fi re to the full heat setting. Turn the Control Knob 'C' fully clockwise (max temperature
setting) to warm the room rapidly. When the room temperature has reached the desired level, turn the thermostat
20