Klarstein HOT SPOT CRYSTAL IR Mode D'emploi page 25

Setting the current day of the week and time
When you turn on the unit, P mode is activated. In P mode, you can set the day of
the week and the time. In P mode there is no heating operation instead.
1. Change the day of the week by pressing and holding the SET button for
5 seconds. Let go of the button when the correct day of the week lights up.
The day of the week is indicated by the numbers in the upper line.
1 Monday
2 Tuesday
3 Wednesday
4 Thursday
5 Friday
6 Saturday
7 Sunday
2. Change the set hour by pressing and holding the MODE button for 5 seconds.
A run of the hours begins. Release the button when the correct hour is
displayed.
3. Change the set minute by pressing and holding the MIN button for 5 seconds.
A run of minutes begins. Release the button when the correct minute is
displayed.
Setting the weekly program
In W mode, you can set the weekly program. On the set days of the week and set
hours of the day, the full heating capacity is shaded.
1. Press the SET button to enter W mode (W mode indicator lights up).
2. Select the days of the week on which the heating program is to be activated
by pressing the MODE button. You can choose between a single day, all days,
or a combination of days set at the factory. The days of the week on which
the heating program is activated are marked with the indicator for active
weekdays (4). The following combinations can be set. (1), (2), (3), (4), (5), (6), (1,
3, 5), (2, 4, 6), (6, 1). (1, 2, 3), (4, 5, 6), (1, 2, 3, 4, 5, 6, 7), (1, 2, 3, 4, 5), (1, 2, 3, 4,
5, 6), (7).
3. Press the keys ∧ and ∨ to select the hours of the day when you want to heat.
You can choose from various factory-set combinations of hours (from 0-24
hours).
Note: You can select the hours for 10 seconds after activating the W mode. If you
then want to set the hours, briefly exit W mode by pressing the SET key. Return to
W mode immediately afterwards by pressing the SET button again.
EN
25