Safety Instructions - Klarstein HOT SPOT CRYSTAL IR Mode D'emploi

EN
18

SAFETY INSTRUCTIONS

Read and follow all the instructions in this manual, even if you feel familiar
with the unit. Keep the instruction manual for future reference. When using an
electrical device, the safety instructions must be followed, including the following:
• Only use the voltage indicated on the nameplate of the heater.
• Do not obstruct the airflow at the air inlet or outlet in any way as the unit may
overheat and become a fire hazard.
• Do not cover the ventilation slots or the air inlets and outlets by placing the
unit against a surface. All objects must be at least 1 meter away from the
front, sides, and rear.
• Do not place the appliance near a heat source.
• Do not operate the unit in an environment where petrol, paint or other easily
flammable substances are stored.
• This equipment will become hot during use. Do not allow bare skin to touch
the hot surface.
• Switch off and allow to cool before moving.
• Do not use the appliance to dry laundry.
• Do not insert foreign objects or metal objects into the interior of the appliance
or the ventilation slots as this may result in electric shock, fire or damage to
the appliance.
• Do not immerse the appliance in liquid or allow water to run inside as this may
result in electric shock.
• Do not operate the equipment with a damaged power cord, plug, or socket
after the equipment has malfunctioned, been dropped, or is damaged in any
way. Refer the product to an authorized electrician for inspection, electrical or
mechanical adjustment, maintenance, or repair.
• Do not operate the equipment with wet hands.
• The most common cause of overheating is the buildup of dust and lint on
the product. Ensure that these deposits are regularly removed by pulling the
power plug and vacuuming the air vents and grill.
• Always unplug the appliance before cleaning. Do not use abrasive cleaners
for cleaning. Clean with a damp (not wet) cloth that has only been dipped in
soapy water.
• Do not connect the appliance to the power supply until it has been fully
assembled.
• The unit is not intended for outdoor use.
• Do not use the unit in the immediate vicinity of a bath, shower, swimming
pool or other liquid.
• Always operate in an upright position.
• Switch off and allow to cool before moving.
• Do not operate with a coiled cable as heat is highly likely to form and is
sufficient to constitute a hazard.
• The use of an extension cord is not recommended for this unit.
• Do not unplug the power cord until the power is turned off.