Proper Width; Removing Extensions - Munchkin IT FITS Notice D'installation

PROPER WIDTH

Measure the width of the opening where the gate will be installed. Be sure to measure at
the narrowest point. For example, include any baseboards in your measurement.
Your gate fits openings from 28 to 36 inches wide using the included extensions. DO NOT
attempt to install this gate for any other sizes.

REMOVING EXTENSIONS

If your opening is between 33.6 and 36 inches, you DO NOT need
to remove any extensions. Please skip to the next section:
Gate Placement. For openings between 30.7 and 33.6 inches
remove 1 extension and openings between 28 and 30.7 inches
remove both extensions before installation.
1. Take out the adjustment rods from the top and
bottom of the outer extension and set them aside
for now. Pull out the plastic plugs that housed the
rods you took out above and set these aside as well.
You may need to use a flathead screwdriver to
remove them.
2. Remove the outer extension from the gate by
pulling the top and bottom extension adapters out
of the corner pockets. Store the extension in a safe
place in case you move your gate to a wider opening
in the future.
3. Re-insert the plugs that you removed in step 1 into
the open pockets of the remaining extension. Be
sure to insert the plugs with the correct side up (the
hole should be closer to the top.)
How to Install
1
2
3
6