Miller DURAFLEX 2PT MA04 Manuel D'utilisation page 14

3.5 Buckle Connection Instructions
SLOTTED MATING BUCKLE
1
Ensure straps are not
twisted. The loose end of
webbing is for adjust-
ment and must always
be located on the outside
(away from the user).
QUICK-CONNECT BUCKLE
1
Ensure straps are not
twisted. The loose end of
webbing is for adjustment
and must always be
located on the outside
(away from the user).
TONGUE BUCKLE
1
Insert the loose strap
of webbing through the
tongue buckle from the
underside.
U s e r In s t ru c t ion s - En g li s h
2
Pass the buckle with the
center bar under the square
link. Turn the center bar
buckle so that the edges
line up with the slots in the
square link. Pull the center
bar buckle completely
through the square link and
allow it to fall into place on
top of the square link.
Push both halves of the
2
buckle together until you hear
a click. Tug on both halves
of the buckle to make sure
it is firmly connected. Pull
loose end of strap to tighten
adjustment of the harness.
Then slide rigid keeper (on
chest strap only) up to buckle
to reduce web sliding in
buckle. Tuck excess webbing
into elastic keepers.
Pull the strap through
2
until snug, placing the
buckle tongue through the
appropriate grommet.
8
3
Pull loose end of strap to
tighten adjustment of the
harness. Then slide rigid
keeper (on chest strap
only) up to buckle to reduce
web sliding in buckle. Tuck
excess webbing into elastic
keepers.
3
To disconnect, push
forward on both release
levers, then pull buckle
apart.
3
Tuck excess webbing into
elastic keepers.