Features; Control Panel Components - Westinghouse iGen2200 Manuel D'utilisation

FEATURES

CONTROL PANEL COMPONENTS

iGen2200
5 3
4
6
7 7
8
9
1. 120 Volt AC, 20 Amp Duplex NEMA 5-20R
Receptacle: Receptacle can supply a maximum of
20 Amps.
2. Fuel Switch: Used to turn fuel valve to the run, choke,
or OFF position.
3. Output Ready LED: Illuminates when the generator
is operating normally. Indicates the generator is
producing electrical power at the receptacles.
4. Overload LED: Indicates that the generator is
overloaded.
5. Low Oil LED: Indicates low oil level. When the oil
level in the crankcase falls below the safe operating
limit, the low oil level indicator will illuminate and the
generator will automatically shut off the engine.
6. USB Ports: Two-port 5V/2.1A USB outlet. Accepts
Type A USB plugs.
8 | Westinghouse Outdoor Power Equipment, LLC
10 11
9
2
7 7
6
1
5
4
3
7. Parallel Operation Outlets: A compatible
Westinghouse Inverter Generator can be
connected for additional power output.
8. Eco Mode: Eco mode minimizes fuel consumption
and noise by adjusting the engine RPM to the
minimum required for the current load.
9. Ground Terminal: The ground terminal is used to
externally ground the generator.
10. Overload Reset: The generator inverter will
automatically switch OFF all AC output to protect
the generator if overloaded or if there is a short
circuit in a connected appliance.
11. 15 Amp AC Circuit Breaker (iGen2200): Circuit
breaker limits the current that can be delivered
through the NEMA 5-20R receptacle to 15 Amps.
12. LED Data Center (iGen2500): Displays remaining
run time (F), power output in kW (P), fuel level in
liters (L), voltage output (V), and lifetime hours.
iGen2500
10
12
2
8
1