Beko MWOTR 30200 CSS Manuel D'utilisation page 31

Masquer les pouces Voir aussi pour MWOTR 30200 CSS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
5
5. Insert 2 self-aligning screws through outer top
cabinet holes. Turn two full turns on each screw.
5
6. Tighten center screw completely.
7. Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall
and the top cabinet.)
8. Install grease filters. See the Owner's Manual
packed with the microwave.
C5. Installing or change the charcoal
filter
The charcoal filter is factory installed
C
in recirculating models. Follow these
steps to replace a filter or to install a
filter after converting a vented mod-
el to recirculating operation.
Over The Range Convection Microwave Oven / Installation Manual
1. Remove screws on top of grille using a #1
Phillips screwdriver.
2. Open the door.
3. Remove the grille. Pull the grille straight off.
6
4. Install the charcoal filter: Insert filter upper in
the unit and then pull down filter. When properly
installed, the wire mesh of the filter should be
visible from the front.
Insert mesh-side up
Charcoal
Filter
31 / 63 EN

Publicité

Chapitres

Table des Matières
loading

Table des Matières