Beko MWOTR 30200 CSS Manuel D'utilisation page 20

Installation
5
A4. Check for proper damper opera-
tion
Blower Plate
Exhaust Adaptor
• Make sure tape securing damper is removed
and damper pivots easily before mounting
microwave.
• You will need to make adjustments to assure
proper alignment with your house exhaust duct
after the microwave is installed.
A5. Mount the microwave oven
C
For easier installation and person-
al safety, we recommend that two
people install this microwave oven.
A
Do not grip or use handle during in-
stallation.
C
If your cabinet is metal, use the ny-
lon grommet around the power cord
hole to prevent cutting of the cord.
C
We recommend using filler blocks if
the cabinet front hangs below the
cabinet bottom shelf.
20 / 63 EN
Damper
Back of
Microwave
Over The Range Convection Microwave Oven / Installation Manual
A
If filler blocks are not used, case
damage may occur from overtight-
ening screws.
1. Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
2. Rotate front of oven up against cabinet bottom.
When mounting the microwave
C
oven, thread power cord through
hole in bottom of top cabinet. Keep
it tight throughout Steps 1–3. Do not
pinch cord or lift oven by pulling cord.
2
3. Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
1