Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
5
5.2 Installation types (choose
A, B or C)
this microwave oven is designed for adaptation to
the following three types of ventilation:
• Outside Top Exhaust (Vertical Duct Type A)
• Outside Back Exhaust (Horizontal Duct Type B)
• Recirculating (Non-Vented Ductless Type C)
Over The Range Convection Microwave Oven / Installation Manual
5.2.1 Outside top exhaust
(vertical duct type A)
Adaptor in Place for
Outside Top Exhaust
installation overview
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Adapting Microwave Blower for
A4. Check Damper Operation
A5. Mount Microwave Oven
A6. Adjust Exhaust Adaptor
A7. Connect Ductwork
Adaptor Must Be
Moved to the Back for
Outside Back Exhaust
This microwave is shipped assem-
C
bled for Recirculating. Select the
type of ventilation required for your
installation and proceed to that sec-
tion.
Make sure the screws for the blower
A
motor and blower plate are securely
tightened when they are reinstalled.
This will help to prevent excessive
vibration.
A
Make sure the motor wiring has
been properly routed and secured,
and that the wires are not pinched.
3/8" TO EDGE
along the dotted line.
Trim the rear wall template
12"
NOTE: IT IS VERY IMPORTANT
TO
READ AND FOLLOW
THE DIRECTIONS
IN THE INSTALLATION
INSTRUCTIONS
BEFORE PROCEEDING
WITH THIS
REAR WALL TEMPLATE.
serves to position the bottom
4"
mounting plate and to locate
This Rear Wall Template
the horizontal exhaust
1. Use a level to check
outlet.
that the template is positioned
accurately.
one stud on the left or
2. Locate and mark at least
right side of the centerline.
least one wood
It is important to use at
a stud to support the weight
of the microwave. Mark
screw mounted firmly in
two additional, evenly spaced
locations for the supplied
toggle bolts.
3. Drill holes in the marked
for wood screws. For holes
locations. Where there is
a stud, drill a 3/16" hole
a stud, drill 5/8" holes for
that do not line up with
toggle bolts.
DO NOT INSTALL THE
MOUNTING PLATE
AT THIS TIME.
4. Remove the template
from the rear wall.
5. Review the Installation
Instruction book for your
installation situation.
Darle vuelta a la hoja
para consultar la
versión en Español.
to align with holes in the
Locate and mark holes
mounting plate.
IMPORTANT:
STUD ON EITHER SIDE
OF
LOCATE AT LEAST ONE
THE CENTERLINE.
MARK THE LOCATION
FOR 2 ADDITIONAL,
EVENLY
IN THE MOUNTING PLATE
SPACED TOGGLE BOLTS
AREA.
Locate and mark holes
to align with holes in the
mounting plate.
IMPORTANT:
STUD ON EITHER SIDE
OF
LOCATE AT LEAST ONE
THE CENTERLINE.
FOR 2 ADDITIONAL,
EVENLY
along the dotted line.
MARK THE LOCATION
IN THE MOUNTING PLATE
Trim the rear wall template
SPACED TOGGLE BOLTS
AREA.
17 / 63 EN
Publicité
Chapitres
Table des Matières
