Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
5
7. Serrez les deux vis extérieures qui se trouvent
sur la partie supérieure du four à micro-ondes.
(Lorsque vous serrez les vis, maintenez le
four à micro-ondes contre le mur et l' a rmoire
supérieure.)
8. Installez les filtres à graisse. Reportez-vous au
manuel d' u tilisation qui accompagne le four à
micro-ondes.
5.2.3 Recyclage d'air (évacuation
sans conduit de type C)
3/8" TO EDGE
12"
NOTE: IT IS VERY IMPORTANT
TO
READ AND FOLLOW
THE DIRECTIONS
INSTRUCTIONS
IN THE INSTALLATION
WITH THIS
BEFORE PROCEEDING
REAR WALL TEMPLATE.
4"
This Rear Wall Template
serves to position the bottom
mounting plate and to locate
the horizontal exhaust
outlet.
that the template is positioned
1. Use a level to check
accurately.
one stud on the left or
2. Locate and mark at least
right side of the centerline.
It is important to use at
least one wood
a stud to support the weight
screw mounted firmly in
two additional, evenly spaced
of the microwave. Mark
locations for the supplied
toggle bolts.
locations. Where there
is
3. Drill holes in the marked
a stud, drill a 3/16" hole
for wood screws. For holes
that do not line up with
a stud, drill 5/8" holes for
toggle bolts.
MOUNTING PLATE
DO NOT INSTALL THE
AT THIS TIME.
4. Remove the template
from the rear wall.
5. Review the Installation
Instruction book for your
installation situation.
Darle vuelta a la hoja
para consultar la
versión en Español.
to align with holes in the
Locate and mark holes
mounting plate.
IMPORTANT:
STUD ON EITHER SIDE
OF
LOCATE AT LEAST ONE
THE CENTERLINE.
EVENLY
MARK THE LOCATION
FOR 2 ADDITIONAL,
IN THE MOUNTING PLATE
SPACED TOGGLE BOLTS
AREA.
along the dotted line.
Trim the rear wall template
Vue d'ensemble de l'installation
C1. Fixation de la plaque de montage au mur
C2. Préparation de l' a rmoire supérieure
C3. Vérification de la plaque du ventilateur
C4. Installation du four à micro-ondes
C5. Installation ou changement du filtre à charbon
Four à micro-ondes à convection à hotte intégrée / Manuel d'installation
along the dotted line.
Trim the rear wall template
to align with holes in the
Locate and mark holes
mounting plate.
IMPORTANT:
STUD ON EITHER SIDE
OF
LOCATE AT LEAST ONE
THE CENTERLINE.
FOR 2 ADDITIONAL,
EVENLY
MARK THE LOCATION
IN THE MOUNTING PLATE
SPACED TOGGLE BOLTS
AREA.
Assurez-vous que les vis du moteur
du ventilateur et de la plaque du
A
ventilateur sont correctement ser-
rées lorsque vous les remettez en
place. Cela permet d' é viter des vibra-
tions excessives.
59 / 63 FR
Publicité
Chapitres
Table des Matières
