Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
External exhaust
4
Straight Duct 6" (15.2 cm)
If a rectangular-to-round transition
C
adaptor is used, the bottom corners
of the damper will have to be cut to
fit, using the tin snips, in order to al-
low free movement of the damper.
For back exhaust, care should be tak-
en to align exhaust with space be-
C
tween studs, or wall should be pre-
pared at the time it is constructed by
leaving enough space between the
wall studs to accommodate exhaust.
4.2 Damage – shipment /
installation
• If the unit is damaged in shipment, return the
unit tı the store in which it was bought for repair
or replacement.
• If the unit is damaged by the customer, repair
or replacement is the responsibility of the
customer.
• If the unit is damaged by the installer /if other
than the customer), repair or replacement must
be made by arrangement between customer
and installer.
Over The Range Convection Microwave Oven / Installation Manual
45° Elbow
Roof Cap
Round or
1⁄4
3
" x 10" (8.2 x 25.4
cm) rectangula
5 Ft. (1.5 m)
x
( )
24 Ft. (7.3 m)
x
( )
1 Ft. (0.3 m)
x
( )
Total Ductwork
4.3 Parts included
4.3.1 Hardware packet
Part
You will find the installation hardware contained in a packet
with the unit. Check to make sure you have all these parts.
NOTE: Some extra parts are included.
=
Ft. or m
=
Ft. or m
=
Ft. or m
=
Ft. or m
Quantity
Wood Screws
2
(1⁄4" x 2")
Toggle Bolts (and
2
wing nuts) (3⁄16"
x 3")
Self-Aligning Machine
3
Screws
(1⁄4"-28 x 31⁄4")
Nylon Grommet
1
(for metal cabinets)
11 / 63 EN
Publicité
Chapitres
Table des Matières
