Important Safety Information - Eccotemp 45-H Notice D'utilisation

Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483

IMPORTANT SAFETY INFORMATION

READ ALL INSTRUCTIONS BEFORE USING
Water temperature over 125°F can cause severe burns
instantly or death from scalds. Children, disabled and elderly
are at highest risk of being scalded. See instruction manual
before setting temperature at water heater. Feel water
before bathing or showering. Temperature limiting valves are
4
DANGER!
WATER TEMPERATURE SETTING
Safety and energy conservation are factors to be considered when selecting
the water temperature setting. Water temperatures above 125°F can cause
severe burns or death from scalding. The thermostat is adjusted to its lowest
temperature position when shipped from the factory. Be sure to read and follow
the warnings outlined on the label pictured below.
Product Support: Eccotemp.com/help-desk
Time/Temperature Relationship in Scalds
Water Temperature
120°F
125°F
130°F
135°F
140°F
145°F
150°F
155°F
Table courtesy of Shriners Burn Institute
The chart shown above may be used as a guide
in determining the proper water temperature for
your home
DANGER: Households with small children,
disabled, or elderly persons may require a 120°F.
or lower temperature setting to prevent contact
with"HOT" water.
Maximum water temperature occurs while
burner is on. To find water temperature being
delivered, turn on a hot water faucet and place a
thermometer in the water stream and read the
thermometer.
The temperature of the water at the outlet of
the water heater can be regulated by setting the
temperature on Remote Control . The remote
control was set at 110°F before it was shipped
from the factory.
The illustration to the bottom left illustrates
the Remote Control and how to adjust the water
temperature.
NOTICE: When this water heater is supplying
general purpose hot water requirements for
use by individuals, a thermostatically controlled
mixing valve for reducing point of use water
temperature is recommended to reduce the risk
of scald injury. Contact a licensed plumber or the
local plumbing
authority for further information.
NOTICE: The factory recommended operating
temperatures are between 90°F and 140°F.
Shop Online: Eccotemp.com/products
Time To Produce a Serious Burn
More than 5 minutes
1 1/2to 2 minutes
About 30 seconds
About 10 seconds
Less than 5 seconds
Less than 3 seconds
About 1 1/2 seconds
About 1 second
Store Locator: Eccotemp.com/locator