Connect The Ethernet Cable - Cognex In-Sight 7000 Série Manuel D'utilisation

Connect the Light Cable (Optional)
Tip: The space between the vision system connectors is limited; it is
recommended to first connect the Light cable to ensure enough space for the
connection of the Ethernet cable and Breakout cable.
1. Remove the protective cap from the LIGHT connector, if present.
2. Connect the Light cable's M12 connector to the vision system's LIGHT
connector.
3. Connect the other end of the Light cable to an external lighting device (for
example, a strobe light).

Connect the Ethernet Cable

1. Connect the Ethernet cable's M12 connector to the vision system's ENET
connector.
2. Connect the Ethernet cable's RJ-45 connector to a switch/router or PC, as
applicable.
Connect the Breakout Cable
Note: Unused bare wires can be clipped short or tied back using a tie made of
non-conductive material. Keep all bare wires separated from the +24VDC
wire.
1. Verify that the 24VDC power supply being used is unplugged and not
receiving power.
9