Cognex In-Sight 7000 Série Manuel D'utilisation page 12

2. Optionally, connect the I/O or serial wires to an appropriate device (for
example, a PLC or a serial device). Refer to Breakout Cable Specifications
on page 12 for wiring details.
3. Attach the Breakout cable's +24VDC (Red wire) and 24V Common (Black
wire) to the corresponding terminals on the power supply. Refer to
Breakout Cable Specifications on page 12 for wiring details.
CAUTION:
observe the polarity shown.
4. Connect the Breakout cable's M12 connector to the vision system's PWR
connector.
5. Restore power to the 24VDC power supply and turn it on if necessary.
Install Software and Documentation
To configure an In-Sight vision system, In-Sight Explorer software must be installed
on a networked PC. In-Sight software is available as a free download from the
In-Sight support site: http://www.cognex.com/Support/InSight.
Log On to the Vision System
1. Open the In-Sight Explorer software.
2. From the Get Connected Application Step, select your In-Sight vision
system from the Select an In-Sight Sensor or Emulator group box and press
the Connect button.
Never connect voltages other than 24VDC. Always
10