Connect the Ethernet Cable
1. Connect the Ethernet cable M12 connector to the vision sensor Ethernet
connector.
2. Connect the Ethernet cable RJ-45 connector to a switch/router or PC, as
applicable. For PoE models, connect the Ethernet cable to a PoE switch
port or other PoE sources.
Connect the Breakout Cable (Optional for
PoE Models)
CAUTION:
If you purchased an In-Sight 2000 vision sensor with PoE (Power
over Ethernet) model, the Breakout cable is used only to connect the I/O or
serial wires to a PLC or a serial device. Do not connect the Breakout cable to a
24VDC power supply.
Note: You can clip unused wires short or use a tie made of non-conductive
material to tie them back. Keep bare wires separated from the +24VDC wire.
1. Verify that the 24VDC power supply is unplugged and not receiving power.
2. Optionally, connect the I/O or serial wires to an appropriate device (for
example, a PLC or a serial device).
3. For non-PoE models, attach the Breakout cable +24VDC (red wire) and
GROUND (black wire) to the corresponding terminals on the power supply.
CAUTION:
observe the polarity shown.
Never connect voltages other than 24VDC. Always
10