Installing The Camera - Dell Precision 7550 Instructions De Service
Masquer les pouces
Voir aussi pour Precision 7550:
- Guide de maintenance (104 pages) ,
- Guide de configuration et des caractéristiques (48 pages) ,
- Guide de configuration et de spécifications (47 pages)
Table des Matières
Publicité
Steps
1. Peel the adhesive tape that covers the camera module.
2. Disconnect the display cable from the camera module.
3. Gently pry the camera shutter cap from the top edge of the camera shutter and remove it from the display back cover.
4. Gently pry the camera module from the display back cover.
Installing the camera
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the camera and provides a visual representation of the installation procedure.
Steps
1. Place the camera module in its slot on the display back cover.
2. Place the camera shutter cap on the top edge of the camera shutter.
3. Connect the display cable to the camera module.
4. Adhere the adhesive tape to cover the camera module.
Next steps
1. Install the
display
panel.
2. Install the
display
bezel.
3. Install the speaker.
4. Install the
display
assembly.
5. Install the
system
board.
6. Install the
GPU
card.
7. Install the
GPU power
cable.
8. Install the
inner
frame.
9. Install the
heat-sink
assembly.
10. Install the
primary
memory.
11. Install the keyboard.
12. Install the
keyboard
lattice.
90
Démontage et remontage
Publicité
Table des Matières
