Table des Matières
Publicité
The street panel´s parameters can be programmed on the keypad.
1.1 Accessing Programming. A + 4444 (default code).
If the code is correct, a confirmation tone sounds (beep-beep).
1.2 Configuring the different Parameters
The configuration of a parameter is done by entering: two digits of its position, and
a beep is heard and the desired value (1,2,3 or 4 digits relative to the parameter
function).
If the value is correct, a confirmation tone sounds (beep-beep) and the new value is saved. If not
correct you will hear the error sound (beep-bop).
In order to exit the programming press 'A' when we are entering the menu´s parameter number.
You can also exit by waiting 60 seconds without pressing any key.
Configuration of a Parameter:
A + Access code for programming + Position + Possible Values
PROGRAM THE PANEL NUMBER
Position
Adjustments Parameter
06
Configuration of a panel number:
A + 4444 + 06 + 0-9
Example:
• Change panel number 2:
A 4444(beep-beep) 06 (beep) 2 (beep-beep)
If your installation is characterised by having General Entrances, Interior Blocks and/or
Sub-blocks, you must also program:
Position
Adjustments Parameter
03
04
Block Num. (BK)
05
Sub-Block num. (BS)
We recommend filling in the amplifier´s sticker once each panel is programmed.
Examples:
General Entrance and
panel number 3
X
RESET TO DEFAULT VALUES (if necessary)
A 4444 (beep-beep) 13 (beep) 1 (beep-beep)
Panel Num. (PL)
Possible Values [default]
0: Sub-Block (SB)
Panel type
[1]: Block (BK)
2: General entrance (GE)
Block 1 and
panel number 2
X
3
Possible Values [default]
0-9 [0]
2
00-99
[00]
00-99
[00]
Sub- block 2 and panel
number 3, belonging to block 1
01
X
2
Comments
Panel number
Comments
Configuration of the
panel type.
Block number the panel
belongs to.
Sub-Block number the
panel belongs to.
02
01
3
KIT AUDIO SKYLINE DUOX PLUS 3-12 L
55
Publicité
Table des Matières
