Acoustic Warning Signals; Service And Maintenance - Festool CARVEX PSC 420 EB Mode D'emploi

English
9.2 Lighting
WARNING
Stroboscopic light could lead to misjudge­
ment of the saw blade position
Risk of injury
► Ensure the work area is well illuminated.
A steady light or stroboscopic light is installed
to illuminate the cutting line:
Up to approx. 2100 rpm: Steady light
From approx. 2100 rpm upwards: Stroboscopic
light
In the overhead position (+/- 45°), the
lighting is switched off completely.
If required, you can adjust the lighting:
► Plug in the electric power tool.
► Press both buttons [1-2] simultaneously
and hold for approx. 10 s until a beep
sounds.
► Release both buttons [1-2].
► Press the left button (on the pendulum
stroke side) the specified number of times
to set the desired mode:
Mode Indication dur­
ing configura­
tion
1 Light flashes
2 Light on
3 Light off
► Press the right button to save the setting.
9.3

Acoustic warning signals

Acoustic warning signals sound and the ma­
chine switches off in the following operating
states:
20
Behaviour during op­
eration
With stroboscope
(standard)
Steady light without
stroboscope
Light switched off
Battery flat or machine over­
loaded.
–
–
Machine is overheating.
–
LiIon battery pack is faulty or
has overheated.
–

10 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
10.1 Observe the following information
► Check the guidance roller regularly for
wear.
► Regularly remove dust deposits from the
chip guard.
► Regularly clean the base runner to prevent
scratches and cores on the surface.
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
► To ensure constant air circulation, always
keep the cooling air openings in the motor
housing clean and free of blockages.
►
Change the battery.
Place the machine under
reduced stress.
You must allow the ma­
chine to cool beforeusing
again.
Once the battery pack has
cooled, perform a func­
tional check using the
charger.