Fan - Atag WG3/4U Futura Mode D'emploi Et Instructions D'installation

fan

(continued)
OFF
intensive setting
Press button
The extractor hood switches to its highest setting for 10
minutes (setting 4). In the control panel the 4
flashes.
After 10 minutes the extractor hood switches back to the
original setting.
switching off the fan
Repeatedly press the key
control panel are off or press key
seconds in order to switch off the extractor hood.
automatic continued operation
Choose the fan setting desired and press button
The extractor hood remains at the selected setting for 10
minutes, after which the extractor hood is automatically
switched off.
If the lighting was switched on during the automatic
continued running, it will remain switched on. The lighting
will be automatically dimmed to 30-40% of the maximum light
strength.
Clean Air function
You can use the Clean Air function to regularly freshen the
air in your residence.
During the Clean Air function, every hour the extractor hood
operates for 10 minutes on setting 1. It then remains
switched off for 50 minutes. This cycle repeats for 12 hours.
GB 4
ON 12h
for a minimum of 2 seconds.
ON
th green LED
until all green LEDs in the
OFF
for at least 2
OFF
.
12h
fan
(continued)
OFF
Press button
Clean Air function. The 4
flashes for as long as setting 1 is switched on (duration 10
minutes). The 4
off phase (duration 50 minutes).
After 12 hours the Clean Air function is automatically
switched off. Press button
switch off the Clean Air function after a shorter period.
Attention: if you switch on the extractor hood during use of
the Clean Air function, the Clean Air function will be
cancelled and the extractor hood will continue to operate on
the programmed setting.
grease filter indicator
If the 1
filter immediately.
Replace the cleaned filter and erase the electronic memory
by pressing the
The 1st red LED stops flashing.
ON 12h
for about 4 seconds to switch on the
12h
th green LED in the operational panel
th green LED is permanently lit in the switched
for about 4 seconds to
12h
st red LED in the control panel starts to flash, clean the
button for approx. 5 seconds.
OFF
GB 5