YAKINIKU Kamado Grill Instructions page 42

Assembly instructions
6
5
1
A
C
Important! - Remove all packaging before use, but keep the safety instructions and
IMPORTANT!
- Remove any packaging before use, but retain the safety instructions and
store them with this product. Ensure that the lid is closed prior to assembly. keep them with this product. Make sure the lid is closed for assembly.
STEP 1
- Attach 4 x long gaskets/self adhesive pads (5) and 4 x short gaskets/self adhesive
pads (6) to the 4 x stand leg sections (1), as pictured. Ensure the long gasket (5) is
STEP 1 - Attach 4x long gaskets/adhesive cushions (5) and 4x short gaskets/adhesive
attached to the inside of the angled section of the leg and the short gasket (6) is
cushions (6) to the 4x standard leg parts (1), as shown.
attached to the end of the stand leg section (1).
Make sure that the long gasket (5) is attached to the inside of the oblique part of the
STEP 2
- Attach a caster wheel to each stand leg section (1) by pushing the preattached
leg and that the short gasket (6) is attached to the end of the standard leg part (1).
bolt on the caster wheels (3 & 4) through the hole in the stand leg section (1) add
the washer (B) and secure each with 1 x domed nut (A). Tighten
STEP 2 - Attach a swivel wheel to each standard leg section (1) by pressing the pre-
with spanner provided. Repeat process for all stand leg sections (1).
attached bolt on the swing wheels (3 and 4) through the hole in the standard leg sec-
STEP 3
- Insert 2 x cross connectors (2) into open ends of 1 x stand leg section (1) with flat
tion (1), add the ring (B) and secure it with 1 x dome nut (A). Tighten with included
side facing down towards caster wheel. Insert 2 x screws (C)
key. Repeat process for all legged sections (1).
into each cross connector (2) to hold them in place. Do not tighten fully.
STEP 4
- Loosely attach 3 x remaining stand leg sections (1) to cross connectors (2) using
STEP 3 - Insert 2x cross connectors (2) into open ends of 1 x standing leg section (1)
12 x screws (C) , ensuring the 2 x caster wheels with brake (3) are together on the
with the flat side facing down towards the swivel wheel. Place 2 x screws (C) in each
rear of assembled stand. Ensure the gaskets (5 & 6) are facing upwards.
STEP 5
cross connector (2) to hold them in place. Don't tighten completely.
- Tighten all 16 x screws (C) with a Phillips screwdriver to ensure the stand is secure
and steady.
STEP 6
- Press down on the levers on the caster wheels
EN
42
Assembly
2
3
or
4
B
7
®