Mobile Home Installation - England's Stove Works 25-CBEP Manuel D'installation Et D'opération

Mobile Home Installation

 As with all installations involving this unit, the use of outside combustion air is
mandatory and MUST be used. Please see the "Outside Air" section on page
15 for more information regarding outside air connections.
 The pellet stove MUST be secured to the floor of the mobile home using lag
bolts and the holes provided in the bottom of the pedestal for this purpose.
 The pellet stove MUST be grounded with #8 solid copper grounding wire (or
equivalent), terminated at each end with an NEC approved grounded device.
 Carefully follow all clearances listed in the appropriate section of this manual
AND follow the venting manufacturer's minimum clearance requirements.
Similarly, be certain the venting system used is approved for mobile home use.
 Installation must be in accordance with Manufacturers Home & Safety Standard
(HUD) CFR 3280, Part 24 as well as any applicable local codes.
THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME
FLOOR, WALL AND CEILING/ROOF MUST BE MAINTAINED.
-The instructions below are for all installations-
 Enclosed space such as an attic, garage or crawl space.
For high altitude installations (above 4,000 ft.), the vent pipe should be increased from
Do not install or operate this unit outside, in a greenhouse,
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
INSTALLATION
CAUTION
Caution
NEVER draw outside combustion air from:
 Wall, floor or ceiling cavity.
WARNING
DO NOT INSTALL IN A SLEEPING ROOM.
3-inch (3") to four-inch (4").
or in any area that is high in moisture.
14