Commissioning; Operation - Schluter Systems LIPROTEC LT EK 24V30W Notice D'utilisation

EN

Commissioning

7 Commissioning
In order to put a power pack into service, proceed as follows:
Make sure all loads are correctly mounted and

connected as desired.
Switch on the mains power supply.

If you use an on-site light switch (see Chapter 6.1 "Types

of connection"), switch on the power supply using the
connected light switch.
If the light does not work properly, switch it off again and

read more in Chapter 10 "Troubleshooting".
8

Operation

The power pack does not having control or switch elements.
If you have connected the power pack to an on-site light
switch, you can turn it on and off with this.
If you have switched a receiver between the power pack and
LED strip, read the operating instructions of the receiver.
56 Directions for use for the power pack