Mount At Installation Point; Connection - Schluter Systems LIPROTEC LT EK 24V30W Notice D'utilisation

EN

Connection

5.2 Mount at installation point

Make sure that the scope of protection is observed

according to DIN VDE 0100-7001 when the components
are used in bathrooms or wet rooms.
Make sure that the installation complies with local

requirements. Note the state-specific discrepancies in
requirements in the documentation for the LIPROTEC-
System.
Make sure that the power pack is not exposed to any

strong vibrations or mechanical exposure at the
installation site.
Make sure that there is sufficient ventilation.

Attach the power pack reversibly using suitable screws,

washers and plugs. Use the power pack mounting
brackets.
6 Connection
Risk of fire on overloaded connections!
Burning components and cables can lead to severe or
deadly injuries.
Always connect only one cable to the connection

terminals or terminal box.
Follow the special directions in the directions for use

in case several components should be connected.
50
DANGER
Directions for use for the power pack