Connecting The Mains Voltage - Schluter Systems LIPROTEC LT EK 24V30W Notice D'utilisation

EN
Connection
Make sure that the strain relief is effective. Then place

the cable in the clamping area of the strain relief, so that
the non-stripped part is detected by both terminal strips
(see fig. D, item 1) and that the individual wires are not
under tension.
Put the housing on the power pack and secure it with the

screws removed in the first step.

6.2.2 Connecting the mains voltage

In order to connect the power pack to the mains connection,
proceed as follows:
Loosen the screws of the housing next to the "230 V"

label (see fig. D, item 3). Remove the screws and store
them safely.
Take off the housing upwards (see fig. D, item 2).

Attach the wires of the mains cable (L = phase, N =

neutral wire) to the power pack's terminals, Make sure
that the design of the mains cable and the connection to
the connection terminals comply with the local
regulations.
Make sure that the strain relief is effective. Then place

the cable in the clamping area of the strain relief, so that
the non-stripped part is detected by both terminal strips
(see fig. D, item 1) and that the individual wires are not
under tension.
Put the housing on the power pack and secure it with the

screws removed in the first step.
54 Directions for use for the power pack