Siebert S202 Série Manuel D'utilisation page 35

Display test
In menu item F one can set whether a display test is automatically carried out after
power-on.
The display test can also be activated via the Modbus interface by setting bit 7 in byte 0.
Display test has priority over blanking and the flash function.
Demo operation mode
If in menu item F the setting PlAy is selected, random characters are displayed
one after another. A control of the unit is in this operation mode not possible.
Power-on reset
After the operating voltage is applied, minus signs appear in all digits in order to
signal operational readiness of the unit. If a display test has been preselected in the
menu, it runs beforehand.
Character set
In addition to the numbers 0...9, the character set also contains the other characters
that can be displayed with a 7-segment matrix. They are reproduced in the table
below with the corresponding hex code.
20/2B 2D 30
- 0
41/61 42/62 43
A b C
59/79 5F 63
Y _ c
Parameterization
The parameterization of the unit is done in a monitor display menu. In normal mode,
the monitor display corresponds to the main display. It allows reading the display
values on the back of the units.
BAL S202 MDB M 1.0
31 32 33
1 2 3
44/64 45/65 46/66 47/67
d E F
68 69 4E/6E 4F/6F 52/72 54/74
h i n
34 35 36
4 5 6
48 49 4A/6A 4C/6C 50/70
'
G H
o r t
37 38 39
7 8 9
J L P
75 58/78 other
u € w
2C/2E
.
55
U
35