Settings; The Initial Settings Procedure - Samsung HT-J4500 Mode D'emploi

Settings

The Initial Settings Procedure

• The Home menu will not appear if you do not
configure the initial settings.
• The OSD (On Screen Display) may change in
this product after you upgrade the software
version.
• The access steps may differ depending on the
menu you selected.
1.
Turn on your TV after connecting the product,
and then turn on the product. When you turn
on the product for the first time, the product
automatically displays the Setup Language
screen.
2.
Press the ▲▼ buttons to select the desired
language, and then press the v button.
3.
Press the v button to start function setup.
Setup
TV Aspect and Network will be set.
Each setting may be changed later under "Settings"
4. The TV Aspect Ratio screen appears. Press
the ▲▼ buttons to select a TV aspect ratio, and
then press the v button.
You have four choices:
16:9 Original - For widescreen TVs. Displays
widescreen pictures in their original 16:9 format
and 4:3 pictures (the old, standard format) in 4:3
pillar box format with black bars on the left and
right.
16:9 Full - For widescreen TVs. Displays
widescreen pictures in their original 16:9 format
and expands 4:3 pictures to fill the 16:9 screen.
4:3 Letter Box - For older, standard screen,
analogue TVs. Displays 4:3 pictures in full screen
and 16:9 pictures in letter box format that retains
the 16:9 aspect ratio but puts black bars above
and below the picture.
Start
a Previous " Select
12
4:3 Pan-Scan - For older, standard screen,
analogue TVs. Displays 4:3 pictures in full screen
and 16:9 pictures in Pan-Scan format that fills
the screen, but cuts off the left and right sides of
the picture and enlarges the middle vertically.
5. The Network - Wired screen appears.
- If you have a network with dynamic IP
addresses - and most people do - select
Auto, press the v button, and then go to
Step 6.
- If you have a network with static IP addresses,
we suggest you select Skip by pressing the
BLUE (D)
button. (See page 17)
- If you have no network, select Skip by
BLUE (D)
pressing the
Settings Complete screen appears, and then
the Home screen appears.
If you skip network setup here or the setup does
✎
not work correctly, you can set up the product's
network connection later. (See page 17)
Setup | Network - Wired
Choose the method to configure Internet Protocol (IP). Please make sure that Ethernet
cable is connected.
Auto : Configure IP automatically.
Auto
6.
The product verifies the network connection
and then connects to the network. When it is
done, press the v button. The "Initial settings
completed." screen appears, and then the
Home screen appears.
Setup | Network - Wired
MAC Address (d0:66:7b:dc:28:fc)
✓
IP Address, Subnet Mask, Gateway, DNS Server
✓
Gateway Ping
✓
Internet Service Test
✓
Your network is operating properly. If you still have a network problem, contact your
network service provider.
- English
button. The Initial
Manual
a Previous d Skip < Move " Select
OK
" Select