Recording - Renkforce TP-1000 Notice D'emploi

c) Recording
• Cassettes can only be recorded in drive B.
• Push the button POWER (1) to switch on the device.
• Push the drive button 5 /
• Insert an unrecorded cassette into drive B with the tape opening down.
• Close the drive cover again.
• In case of a CrO2-cassette, push the button REC CrO2 (8). With the button activated, a red control ID lights
up in the display (4) above the button.
• Put the switch NOISE REDUCTION (3) into the desired position:
Cassette is to be recorded with noise reduction system > Push switch into the ON position.
Cassette is to be recorded without noise reduction system > Push switch into the OFF position.
Recording from an external audio source
• Select the desired audio source from which you want to record the signal at your amplifier.
• Push the button 3 PAUSE at drive B.
• Push the buttons
• Start playback at your recording source and push the button 3 PAUSE at drive B again to start play-back.
• During the recording, a light indicator LED lights up in the display (4) at the upper right.
• Control the recording with the controller REC LEVEL (6) by setting the controller so that the red segments
of the balancing display in the display (4) flash briefly only during signal peaks.
• Push the button 3 PAUSE again to interrupt recording briefly. To continue the recording, push the button
3 PAUSE again.
• Push the button 5 /
• Push the button 5 /
Recording is automatically stopped when the tape end has been reached.
30
STOP/EJ. of drive B.
REC and 6 PLAY of drive B at the same time.
STOP/EJ. to stop the recording.
STOP/EJ. again to remove the inserted cassette.