Set-Up - Renkforce TP-1000 Notice D'emploi

7. Set-Up

When selecting the set-up location, please take into consideration the room layout such as the where-
abouts of the nearest socket, etc.
When selecting the set-up site, observe that direct sunlight, vibration, dust, heat, cold and moisture must
be avoided. There also must not be any strong transformers in the device's proximity.
Only operate the device on a stable, horizontal surface. There must be enough air circulation to
permit dissipation of the generated heat. Therefore, only place the device on a level surface and
not on carpets, etc. Do not cover up the ventilation slots in the casing.
Non-observance of this note may cause damage to the device.
Do not drill or screw any additional screws into the casing to mount the device. This damages
the device and it may become possible to touch potentially fatal mains voltage.
Make sure you position the device safely. Falling devices may pose a significant risk of acci-
dent.
Due to the diversity of furniture paints and polishes used, it is possible that the device's feet will
leave visible residue on furniture due to chemical reaction.
The device therefore should not be placed on valuable furniture surfaces without any suitable
protection.
24