Comelit 3451 Manuel Utilisateur page 3

Self-testing
On power-up, the device runs a diagnostic test of the connections to
check for correct communication and confi guration.
The message PLEASE WAIT indicates self-testing in progress.
On completion of self-testing, press the
standby.
Finding a name in the directory
√ In standby
1. Press to access the directory search function.
2. Enter the name (full name or just the fi rst letter).
M_
ESC
Press the relevant key repeatedly to enter special characters.
Special characters
,;:._-#*"1 ABCÅÄĄÆßČĆ2
GHI4 JKLŁ5
PQRS7 TUVÜ8
space 0
3. Press to start searching.
4. Scroll through the directory using
MARIO ROSSI
CODE:
SCROLL
5. Press to make the call or
key to put the module in
OK
CANC
DEFÉĘĚ3
MNOŃÖØÓ6
WXYZ9
.
002
CALL
to exit.
Calling a user
√ In standby
1. Enter the user code (e.g.: 2).
2. Press to make the call or
CALL USER
CALL
or:
1. Scroll through the directory using
2. Press to make the call or
MARIO ROSSI
CODE:
SCROLL
Activating the lock-release relay
by entering the password code
√ In standby
1. Press .
2. Enter the password code.
ENTER PASSWORD:
OK
3. Press to confi rm or to cancel and exit.
» A confi rmation message will appear on screen when the procedure
is complete.
Activating the relay with the RFID key
√ In standby
„ Pass the key near the RFID sensor.
KEY ACCEPTED
» The green LEDs light up for a few seconds.
» "KEY ACCEPTED" appears on the display.
» The lock-release contact is opened.
KEY REJECTED
» The red LED fl ashes.
» "WRONG KEY" appears on the display.
to cancel and exit.
_ _ 2
CANC
.
to exit.
002
CALL
******
CANC
3