CyberPower OR600ELCDRM1U Manuel D'utilisation page 4

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1. Your new UPS may be used immediately upon receipt. However, recharging the battery for
at least 8 hours is recommended to ensure that the battery's maximum charge capacity
is achieved. Charge loss may occur during shipping and storage. To recharge the battery,
simply leave the unit plugged into an AC outlet. The unit will charge in both the on and off
position.
2. With the UPS unit off and unplugged, connect the computer, monitor, and any externally
powered data storage device (Zip drive, Jazz drive, Tape drive, etc. into the battery power
supplied outlets. DO NOT plug a laser printer, copier, space heater, vacuum, paper
shredder or other large electrical device into the UPS. The power demands of these
devices will overload and possibly damage the unit.
3. To protect a fax, telephone, modem line or network cable, connect a telephone cable or
network cable from the wall jack outlet to the IN jack of the UPS. Then connect a telephone
cable or network cable from the OUT jack on the UPS to the modem, computer, telephone,
fax machine, or network device.
4. Plug the UPS into a 2 pole, 3 wire grounded receptacle (wall outlet). Make sure the wall
branch outlet is protected by a fuse or circuit breaker and does not service equipment with
large electrical demands (e.g. air conditioner, refrigerator, copier, etc. Avoid using
extension cords. If used, the extension cord must be grounded and rated for 15 amps.
5. Depress the power switch to turn the unit on. The power on indicator light will illuminate
and the unit will "beep".
6. If an overload is detected, an audible alarm will sound and the unit will emit one long beep.
To correct this, turn the UPS off and unplug at least one piece of equipment from the
battery power supplied outlets. Wait 10 seconds. Make sure the circuit breaker is
depressed and then turn the UPS on.
7. To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.
8. To store your UPS for an extended period, cover it and store with the battery fully
charged. Recharge the battery every three months to ensure battery life.
CYBERPOWER GREENPOWER UPS TECHNOLOGY
CyberPower's Green Commitment
CyberPower is dedicated to the development of green products, and has adopted
Green practices throughout its business, including: membership in Climate Savers
Computing Initiative (CSCI), accordance with the Restriction on Hazardous
Substances (RoHS), Waste Electrical and Electronic Equipment (WEEE) protocols,
as well as ISO 14001 and IECQ QC080000. CyberPower pledges to provide the
advanced energy solution for the environment and become a leading eco-friendly
organization in the UPS industry.
Reduce Energy Cost with GreenPower UPS
CyberPower's goal is not only to provide eco-friendly products but also to bring the best value for
consumers. The advanced energy-saving design improves the operating efficiency and eliminates
waste energy consumption. As a result, consumers will enjoy significant energy cost savings with the
Hardware Installation Guide
TM
Technology
4

Publicité

Table des Matières
loading

Table des Matières