Horizon Fitness ELITE T7 Guide D'assemblage page 6

ASSEMBLY STEP 4
6
4
5
10
HZ14_AG_Elite_T7_T9_r1_2.indd 10-11
NO HARDWARE FOR STEP 4
A T7 models only: Slide MAIN FRAME COVERS
(5) over CONSOLE MASTS (4).
B All models: Slide CONSOLE MAST COVERS
(6) over CONSOLE MASTS (4).
ASSEMBLY STEP 5
7
E
C
F
D
4
HARDWARE FOR STEP 5
PART TYPE QTY
E BUTTON HEAD BOLT 6
C SPRING WASHER 6
D FLAT WASHER 4
F ARC WASHER 2
NOTE: Do not fully tighten bolts until step 6.
A Open HARDWARE FOR STEP 5.
B Place RIGHT HANDLEBAR (7) into top of
RIGHT CONSOLE MAST (4).
C Insert 1 BOLT (E), 1 SPRING WASHER (C)
and 1 FLAT WASHER (D) from the front-facing
side of the CONSOLE MAST (4).
D Insert 1 BOLT (E), 1 SPRING WASHER (C)
and 1 FLAT WASHER (D) from the inside-
facing side of the CONSOLE MAST (4).
E Insert 1 BOLT (E), 1 SPRING WASHER (C)
and 1 ARC WASHER (F) from the rear-facing
side of the CONSOLE MAST (4).
F Repeat steps B–E on other side.
7/2/14 3:55 PM
11