10- Solving Operational Problems - Fulgor Milano Sofia 30 Guide D'utilisation Et D'entretien

10 - Solving Operational Problems
EN
Before contacting service, check the following to avoid unnecessary service charges.
PROBLEM
Ignition will not operate
Is the power supply
unplugged?
Has a household fuse been
blown or has the circuit breaker
been tripped?
Surface burners will not operate
Is this the first time the surface
burners have been used?
Is the control knob set correctly?
Are the burner ports clogged?
Surface burner flames are uneven yellow and/or noisy
Are the burner ports clogged?
Are the burner caps positioned
properly?
Is propane gas being used?
Surface burner makes clicking noises
Is the burner wet?
Is the cap and gas spreader
positioned correctly?
Is the cooking vessel much larger
than the allocated grate space?
Excessive heat around cookware on cooktop
Is the cookware the proper size? Use cookware about the same size as the surface cooking area, element or surface
Cooktop cooking results not what expected
Is the proper cookware being
used?
Is the control knob set to the
proper heat level?
18
PROBLEM SOLVING STEPS
cord Plug into a grounded 3 prong outlet.
Replace the fuse or reset the circuit.
Turn on any one of the surface burner knobs to release air from the gas lines.
Push in knob before turning to a setting.
See "Super Sealed Surface Burners" section.
See "Super Sealed Surface Burners" section.
See "Super Sealed Surface Burners" section.
The appliance may have been converted improperly. Contact a service technician.
Let it dry.
Make sure the alignment pins are properly aligned see "Super Sealed Surface Burners"
section.
Remove vessel temporarily, if clicking ceases and then returns when putting the vessel
back, it is due to the oversized vessel. You can still continue to cook with the vessel but
the clicking will continue until cooking is complete.
burner. Cookware should not extend more than 1 in (2.5 cm) outside the cooking area.
See "Cookware" section.
See "Setting the Control Knobs" section.