TOPRO TROJA Manuel D'utilisation page 12

TOPRO
F
B
C
D
E
A
12
www.TOPRO.no
TROJA ROLLATOR
Height adjustment
using the memory function
You have the opportunity to set the height of the
handles as a standard so that you easily can find
the height you once set.
This can be necessary when
the rollator is being transported or stored
as compact as possible.
Decide the height of the handlebars.
Count visible holes at the back of the handlebar
tubes.
Unscrew the lock wheel
B
Pull the tube out of the frame.
C
The attached part will now follow the handlebar
tube. Move the attached part
B
on the tube so there are equal holes as counted
earlier. Fit the memory chip
on the handlebar tube in the first available hole
under the attached part
Push the handlebar tube
E
the side frame until the attached part
is locked. Screw the lock wheel
F
Pull the handlebars
then tighten the lock wheel
From now on, when the handlebars are
in the lowest position,
they will stop in the preset position
automatically when pulled up.
A
C
D
C
B
down and into
A
half in.
up until they stop,
A
properly.