Installing The Appliance Into The Wall; Side View - Napoleon NEFL42FH-MT Instructions D'installation Et D'opération

12

3.3.2 INSTALLING THE APPLIANCE INTO THE WALL

Due to the many different materials used on different walls, it is highly
recommended that you consult your local builder before you install this
EN
appliance on the wall.
Select a location that is not prone to moisture and is located at
A.
least 36" (914mm) away from combustible materials such as curtain
drapes, furniture, bedding, paper, etc.
Have two people hold the appliance against the wall to determine
B.
the final location.
Place unit face down on a soft, non abrasive surface. Remove the
C.
bracket from the back of the unit by removing the screws, refer to
Figure 1.
Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket
D.
MUST have the hooks facing upward and be level. NOTE: It is strongly recommended that the
mounting bracket be screwed
into the wall studs where
possible. If the wall studs
cannot be used, ensure that
the supplied plastic anchors
are used to affix the bracket
to the wall and the bracket is
adequately secured.
With the wall mounting bracket installed have two people lift the appliance up and insert the two
E.
hooks on the bracket into the two slots on the back of the appliance.
Check the appliance for stability ensuring that the bracket will not pull free from the wall.
F.
W415-2172 / 08.08.16
HOOK
NEFL42/50FH-MT BRACKET ILLUSTRATED
NEFL60FH-MT BRACKET ILLUSTRATED
MESH TRIM

SIDE VIEW

SCREWS
BODY
21 5/8"
550mm
HOOK