Finishing; Mesh Trim Front Installation - Napoleon NEFL42FH-MT Instructions D'installation Et D'opération

16

4.0 FINISHING

POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
EN
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.1

MESH TRIM FRONT INSTALLATION

THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
FOR MODELS NEFL50/60FH-MT ONLY:
Before installing the mesh trim front, remove the screws securing the paper board on the inside of the
A.
appliance that protects the control panel. Discard the paper board.
Reinstall the screws, see Figure 1. (For recessed installed appliances only)
B.
Remove the 2 screws from the top of the appliance.
C.
Have two people, lift the mesh trim up and away from the appliance, holding the mesh trim vertical
D.
not flat while carrying. Place the mesh trim face down onto a soft, non-abrasive surface, careful not
to flex the mesh trim.
Bend the top tabs flat, see Figure 2
E.
Install the crystal embers, refer to "CRYSTAL EMBER INSTALLATION" section.
F.
Install the mesh trim front by aligning with the pins on the appliance. Press the mesh trim in and down
G.
to securely engage with the brackets. It must be fully engaged to ensure the touch display panel
performs properly.
Secure the mesh trim front using the screws provided to the top of the appliance, see Figure 3.(If fully
H.
recessed, this is not necessary)
FIG. 1
FIG. 2
W415-2172 / 08.08.16
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
WARNING
!
RECONSTRUCTION.
WARNING
!
Pin
Paper
75.1
Paper