Mesh Trim Front Removal; Crystal Ember Installation - Napoleon NEFL42FH-MT Instructions D'installation Et D'opération

FIG. 3
4.2

MESH TRIM FRONT REMOVAL

FOR WALL MOUNT, PARTIAL RECESS AND MANTEL INSTALLED APPLIANCE ONLY:
Remove the 2 screws from the top of the appliance, as shown below.
A.
Have two people, lift the mesh trim up and away from the appliance, holding the mesh trim vertical
B.
not flat while carrying. Place the mesh trim face down onto a soft, non-abrasive surface, careful not
to flex the mesh trim.
Install the crystal embers, refer to "CRYSTAL EMBER INSTALLATION" section. Install the front
C.
mesh trim by aligning with the pins on the appliance. This ensures the touch display panel performs
properly.
4.3

CRYSTAL EMBER INSTALLATION

The mesh trim front must be removed and the appliance must be secured in its final location before the crys-
tal embers are installed.
Carefully place crystal embers into the bottom media tray on the
A.
front of the appliance as illustrated. Apply an even layer from side
to side.
Ensure that no crystal embers touch the mesh trim front during
B.
install. Avoid crystal embers scratching/tearing mesh.
17
EN
W415-2172 / 08.08.16