General Instructions; Unpacking And Testing Appliance - Napoleon NEFL42FH-MT Instructions D'installation Et D'opération

Foyer électrique
Masquer les pouces Voir aussi pour NEFL42FH-MT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.3

GENERAL INSTRUCTIONS

READ THESE INSTRUCTIONS COMPLETELY BEFORE BEGINNING INSTALLATION. FAILURE TO
FOLLOW THEM COULD CAUSE AN APPLIANCE MALFUNCTION RESULTING IN SERIOUS INJURY
ALL ELECTRIC APPLIANCES HAVE HOT AND ARCING OR SPARKING PARTS INSIDE. DO NOT USE
IT IN AREAS WHERE GASOLINE, PAINT OR FLAMMABLE LIQUIDS ARE PRESENT.
THIS ELECTRIC APPLIANCE IS TESTED AND LISTED FOR USE ONLY WITH THE OPTIONAL
ACCESSORIES LISTED IN THESE INSTRUCTIONS. USE OF OPTIONAL ACCESSORIES NOT
SPECIFICALLY TESTED FOR THIS ELECTRIC APPLIANCE COULD VOID THE WARRANTY AND/OR
DO NOT OPEN. RISK OF ELECTRIC SHOCK. NO USER-SERVICEABLE PARTS INSIDE.
SERVICING SHOULD BE DONE ONLY WHILE THE APPLIANCE IS DISCONNECTED FROM THE
TO PREVENT ELECTRIC SHOCK MATCH THE WIDE BLADE OF PLUG TO WIDE SLOT OF
Prior to plugging your appliance into an electrical outlet, verify that the house circuit breakers for the
A.
outlet are on.
The appliance may emit a slight, harmless odour when fi rst used. This odour is normal and it is caused
B.
by the initial heating of internal appliance elements and will not occur again.
If your appliance does not emit heat, consult the operation section of this manual for further
C.
information.
Use with a CSA- or UL-certifi ed surge protector.
D.
Do not route the power cord directly underneath the appliance.
E.
This electric appliance meets the construction and safety standards of H.U.D. for application in manufactured
homes when installed according to these instructions.
As with most electronic devices, your new electric fireplace has been designed to operate at
temperatures between 5°C (41°F) and 35° C (95°F). During the colder winter months, allow the fireplace
to reach room temperature before turning it on.
1.4

UNPACKING AND TESTING APPLIANCE

Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the
appliance operates properly by plugging the power supply cord into a conveniently located 120 Volt, 15
Amp grounded outlet.
NOTE: The NEFL50/60FH-MT appliances are shipped with the mesh trim front not assembled onto the
appliance. Refer to the "MESH TRIM FRONT INSTALLATION" sections for assembly.
WARNING
!
AND/OR PROPERTY DAMAGE.
RESULT IN A SAFETY HAZARD.
DO NOT USE DAMAGED ELECTRICAL CORDS.
POWER SUPPLY CIRCUIT.
RECEPTACLE AND FULLY INSERT.
5
4.8B
W415-2172 / 08.08.16
EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Nefl50fh-mtNefl60fh-mt

Table des Matières