Installing The Appliance; Wall Mount Installation - Napoleon NEFL50HF-BT-LOWC Manuel

3.2

installing the appliance

3.2.1 wall mount installation

note:
The wall mounting bracket is fixed on the back of the appliance.
Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
Select a location that is not prone to moisture and is located at least 3 feet (1m) away from combustible
A.
materials such as curtain drapes, furniture, bedding, paper, etc.
Remove the front surround (see "front surround removal / installation" section).
B.
Have two people hold the appliance against the wall to determine the final location.
C.
Place the appliance face down on a soft, non-abrasive surface. Remove the wall mounting bracket from
D.
the back of the appliance by removing the two screws (Fig. 3-1). Set the bracket aside and discard the
screws.
Remove the two screws at the bottom of the appliance (Fig. 3-2). Set the screws aside.
E.
Mark out the location, then mount the wall mounting bracket onto the wall using screws (supplied) (Fig.
F.
3-3). This bracket MUST have the hooks facing upwards and be level.
note:
It is strongly recommended that the wall mounting bracket be screwed into the wall studs where
possible. If the wall studs cannot be used, ensure that the supplied plastic anchors are used to affix the
bracket to the wall and that the bracket is adequately secured.
Using the two screws previously removed in step E, attach the L-bracket (supplied) to the bottom of the
G.
appliance (Fig. 3-4).
A x 6
Wall
B x 6
Fig. 3-1
Fig. 3-3
installation
EN
Fig. 3-2
E x 1
Fig. 3-4
11
W415-2984 / 01.13.21