Troubleshooting - Napoleon NEFL42FH-MT Instructions D'installation Et D'opération

9.0 TROUBLESHOOTING

TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A
QUALIFIED SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
SYMPTOM
Dim or no flame / LED's are burnt out or
Ember bed is not malfunctioning
glowing or dimming
No warm air coming Room temperature is higher
out of appliance than the appliance setting (if
it is set to room temperature)
Heater is burnt out
Appliance turns off Appliance has overheated
and will not turn on and safety thermal switch
has tripped
House circuit breaker has
tripped
Appliance will not Appliance is not plugged into
come on when an electrical outlet
Power button is
Appliance has overheated
turned ON.
and safety thermal switch
has tripped
Circuit board is burnt out
Remote control Low batteries
does not work
Heater shuts off Room is too warm
automatically
WARNING
!
PROBLEM
Inspect the LED's and replace them if necessary
Reset temperature setting
Inspect the burner and heater assembly and replace it if
necessary
Unplug power cord and allow appliance to cool for 15 min-
utes, then plug in the power cord and turn the power ON.
Reset house circuit breaker
Check plug and plug it in
Unplug power cord and allow appliance to cool for 15 min-
utes, then plug in the power cord and turn the power ON.
Inspect the circuit board and replace it if necessary
Replace batteries in remote control
The heater has a built-in thermostat so it will shut off
automatically once the pre-set temperature is reached. It
will also turn on automatically if the room temperature drops
below the pre-set temperature
TEST SOLUTION
23
EN
W415-2172 / 08.08.16