Operating Instructions; Main Power Button; Operating Touch Display Panel And Remote Control - Napoleon NEFL42FH-MT Instructions D'installation Et D'opération

18

5.0 OPERATING INSTRUCTIONS

EN
TO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY.
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, the appliance will lose its memory function and will reset to factory mode when the power
returns.
5.1

MAIN POWER BUTTON

The Main Power button is located on the front bottom right side of the appliance.
5.2

OPERATING TOUCH DISPLAY PANEL AND REMOTE CONTROL

The touch display panel is shown by LED's on the front bottom right of the appliance. The LED's will
disappear after 10 seconds of no function change. The Main Power button will be dim.
POWER
FLAME - ORANGE
FLAME - BLUE
HEATER
TIMER
TEMPERATURE
WARNING: Do not move or remove the mesh trim panel, when the appliance is plugged in and
operating. This will cause the remote control and touch panel to no longer function.
W415-2172 / 08.08.16
WARNING
!
KNOT BEFORE THROWING AWAY.
Turns the appliance ON/OFF.
Controls Orange Flame brightness.
6 Settings: ( F5-F4-F3-F2-F1-F0 ) Flame dims from F5 to F1.
F5 is the brightest setting and F0 is off.
Controls Blue Flame brightness.
6 Settings: ( F5-F4-F3-F2-F1-F0 ) Flame dims from F5 to F1.
F5 is the brightest setting and F0 is off..
Controls the Heater.
Press button to initiate the heater.
(H0) no heater or blower.
(BL) blower only.
(H1), heater blows warm air (750W)
(H2), heater blows hot air (1500W)
NOTE: Heater functions cycle from H0-BL-H1-H2, Press
and hold the heater button for 5s, the heater and
temperature setting will be locked onto the selected
setting. Hold the button for 5s again, the heater will be
unlocked.
Controls the Timer.
9 Settings: (0.5h, 1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h) Press button
until reach desired setting.
1. Press once: Touch panel indicator becomes active.
2. Press again until desired setting is reached. Digital display
shows setting circles as below.
Display Value
Temperature
NOTE: Press the button for 5 seconds, the temperature
setting will switch from °C to °F. Same way from °F to °C.
0 1 2 3 4 5 6 7 8 9 N
C 18 19 20 21 22 23 24 25 26 27 ON
°
64 66 68 70 72 74 76 78 80 82 ON
F
°