Rs-232C Interface; Rs-232C Specifications; Tcp/Ip-Connection - JVC DLA-RS65 Manuel D'instructions

RS-232C Interface

It is possible to control this machine, if it is connected by an RS-232C cross cable (D-Sub9
pin) to a PC. Otherwise, this machine can be controlled via a computer network by connecting
it with a LAN cable and sending of control commands. Please use it after you have understood
this by reading professional books, or by discussing it with a system administrator.

RS-232C Specifications

This unit
Mode
Character Length
Parity
Start Bit
Stop Bit
Data rate
Data format

TCP/IP-connection

Before you can control it via LAN, you have to establish a TCP-connection via a "3-way-handshake". It is
necessary for a connection authentication to send from the projector "PJ_OK" and - within 5 seconds after
sending a "PJREQ" – to receive "PJACK". Please perform this operation – after confirming the operating
status of the projector - again after establishment of a TCP connection, if you cannot send within 5 seconds
"PJ_NG" or could not receive "PJNAK".
Projector
TCP-layer connection establishment
TCP port number 20554
Three-way handshake
Control PC
Pin No.
2
3
5
1,4,6 - 9
● PC refers to the controller such as a personal computer.
Non-synchronous
8 bit
None
1
1
19200 bps
Binary
Within 5 seconds
ＰＪ_ＯＫ
ＰＪＲＥＱ
Connection authentication procedure
Signal Function
RxD
Receive data
TxD Transmit data
GND Signal ground
N/C -
D0 D1 D2 D3
Start Bit
ＰＪＡＣＫ
Projector Control
ENGLISH
Signal Direction
PC→This unit
This unit→PC
-
-
D4 D5 D6 D7
Stop Bit
87