JVC DLA-RS65 Manuel D'instructions page 72

3
Adjustments and settings in the menu (continued)
[5] Function
Use this function to set command communications, remote control codes,
OFF timer function, etc. You can also reset the lamp time.
Use the UP/DOWN keys to select an adjustment item.
Press the [BACK] key to return to the previous screen.
Items
Trigger
Off
On (Power)
On (Anamo)
Off Timer
Off
1 Hour
2 Hours
3 Hours
4 Hours
High Altitude Mode
On
Off
Communication
Terminal
RS-232C
LAN
Network
Remote Code
A
B
Lamp Reset
72
Operation
Explanation, operation, precautions, settings
Configures 12V output to an external screen equipped with a trigger function.
Settings: Off, On(Power), On(Anamo)
No output.
When turned on, control signals (12V) from the trigger terminal are emitted.
If you turn off the power, the output of the control signal stops.
During standby mode, an output will occur if the [OK] button is pressed.
After cooling, the output stops when you go back to standby.
Control signals (12V) are emitted when the Anamorphic mode is set from "Off" to "A" or
"B". If the Anamorphic mode is set to "A" or "B", the operation in this state equals "On
(Power)".
Sets Off Timer function and its time.
(*) If there are no operations, the unit powers off automatically.
(*) It powers off automatically even while projecting an image.
(*) You will be given a warning 60 seconds before power turns OFF.
Press the [OK] button while the warning is being displayed to delete the warning display.
You cannot configure settings to omit warning display.
Settings: Off, 1 hour, 2 hours, 3 hours, 4 hours
Power is not turned off.
Power is turned off automatically after 1 hour.
Power is turned off automatically after 2 hours.
Power is turned off automatically after 3 hours.
Power is turned off automatically after 4 hours.
Set to use at low pressure locations (900m above sea level).
Settings: On, Off
Set.
Do not set.
Sets the used control terminal. It is not possible to use it at the same time.
Settings: RS-232C, LAN
Sets the RS-232C terminal.
Sets the LAN terminal.
It is displayed, if the setting of the "Communication terminal" to the submenu "[5-1]
Network" is set to "LAN".
Use this function to change the projector's remote control code. The projector can be
operated only with a remote control configured with the same code. To change the remote
control code itself, press "MENU" and [BACK] together for three seconds or more. All of
the buttons on the remote control will begin to blink. Two blinks indicate "Change A to B";
three blinks indicate "Change B to A".
Settings: A, B
Set the projector's remote control code to "A".
Set the projector's remote control code to "B".
Reset of the lamp use time to "0".
Trigger Off
Off Timer
Off
High Altitude Mode
Off
Communication Terminal
RS-232C
Network
Remote Code
A
Lamp Reset
[Off]
[Off]
[Off]
[RS-232C]
[A]