Controls and features
Main body - Front
③ Indicator
STANDBY/ON
LAMP
④ Exhaust Vent
① Lens
This is a projection lens. Please do not look
inside during projection.
Lens cover
The lens cover opens/closes when the power
supply is turned on/off.
(Reference page: 66)
② Remote receiver (front)
Please aim the remote control at this area when
using it.
(*) There is also a remote receiver at the rear.
Main body - Bottom
⑤ Inlets ⑥ Manual button for
lens cover
WARNING
② Remote receiver (front)
65 55
65 55
⑦ Feet
① Lens
Lens cover
③ Indicator
Please see "About the indicator display" for
details. (Reference page: 17)
④ Exhaust Vent
Warm air flows out in order to cool the interior of
the set. Please do not block the vents.
⑤ Inlets (at 3 points on the rear/
bottom)
In order to cool the inside of the unit, air is let
inside. Do not block or prevent the outflow of
hot air. Doing so could lead to failure of the unit.
(*) There are inlets at two points on the right
and left sides of the rear side.
(Reference page: 16)
⑥ Manual operation button of the
lens cover
65 55
The lens cover can be opened when pressed
down.It is used for maintenance and not used
during normal use.
⑦ Feet
The height (0 to 5 mm) can be adjusted by
turning the foot.
When the foot is removed, it can be used as the
mounting holes for the ceiling mount bracket.
(Reference page: 24)
ENGLISH
④ Exhaust
Vent
15