Sony HT-X9000F Manuel D'instructions page 51

 When there is no picture from the
connected device or the picture from
the connected device is not output
correctly, set
Settings] - [HDMI Settings] - [HDMI
Signal Format] - [HDMI IN] to
[Standard format] (page 22).
 If you connect a device supporting
HDCP 2.2, be sure to connect the
device to the HDMI IN jack and the TV
to the HDMI OUT jack of the system.
 The system is connected to an input
device that is not HDCP (High-
bandwidth Digital Content
Protection) compliant. In this case,
check the specifications of the
connected device.
3D content from the HDMI IN jack do
not appear on the TV screen.
 Depending on the TV or video device,
3D content may not appear. Check
the supported HDMI video format
(page 61).
4K video content from the HDMI IN
jack do not appear on the TV screen.
 Depending on the TV or the video
device, 4K video content may not
appear. Check the video capability
and settings of your TV and video
device.
 The picture may not be displayed
properly if the [HDMI Signal Format]
setting is changed. In this case,
change the setting to [Standard
format] (page 22).
 Use a Premium High Speed HDMI
Cable with Ethernet that supports
18Gbps or High Speed HDMI Cable
with Ethernet (page 61).
An image is not displayed on the
entire TV screen.
 The aspect ratio on the media is fixed.
[Setup] - [Advanced
Picture and sound of the device that
is connected to the system are not
output from the TV when the
system is not turned on.
 Set
[Setup] - [Advanced Settings]
- [HDMI Settings] - [Control for HDMI]
to [On] on the system, and then set
[Standby Through] to [Auto] or [On]
(page 47).
 Turn on the system, and then switch
the input for the device playing.
 If connected to devices other than
those manufactured by Sony that
support the Control for HDMI
function, set
Settings] - [HDMI Settings] - [Standby
Through] to [On] (page 47).
HDR contents cannot show as high-
dynamic range.
 Check the settings of the TV and
connected device. For details, refer to
the operating instructions of your TV
and the connected device.
 Some devices may convert HDR
contents to SDR if the bandwidth is
not enough. In that case, set
[Setup] - [Advanced Settings] -
[HDMI Settings] - [HDMI Signal
Format] - [HDMI IN] to [Enhanced
format] if the TV and the connected
device support a bandwidth of up to
18Gbps (page 22). When you select
[Enhanced format], be sure to use a
Premium High Speed HDMI Cable
with Ethernet that supports 18Gbps
(page 61).
Sound
The system cannot connect to a TV
with the BLUETOOTH function.
 When you connect the system and TV
with the HDMI cable (supplied), the
BLUETOOTH connection is canceled.
[Setup] - [Advanced
51
US